BUCHI NIRCal - Manual (Page 141)

Chemometrics
NIRCal 5.5 Manual, Version A 141
3.16.1 Calibrations without Lifecycle
Each new project in NIRCal 5 has an "unnamed" or master calibration, which is created
automatically by importing spectra into the empty project.
This calibration and every calibration created with the menu "Calibration / New" has an "all"
selection for the C-Set spectra, wavelength and property selection automatically and has "editable"
status.
Running the calibration wizard, several new calibrations will be generated, the calibration with the
highest Q-Value is active. The calibrations created by the wizard are outside the normal Lifecycle,
unless they are saved in the database!
Calibrations, which are created but not yet stored in the database are editable and can be deleted
by selecting them in the NIR-Explorer on the right side and pressing "Delete".
Rename the Calibration
The name of an active, editable calibration can be changed by clicking the right mouse button and
selecting: "Rename". It is suggested to give a short, but clear name for each calibration; data as
extention is useful for approved calibrations.
NOTE
The calibration name is part of the Calibration Protocol which is created during calculation. If the
calibration name is changed afterwards, make sure to do a full calculation to get an updated
calibration protocol.
NOTE
Give an appropriate name to the calibration, this allows a correct connection for the application.
Rename is not available for Approved calibrations.
3.16.2 Calibrations with Lifecycle
After saving the project into the database, the calibrations are also stored and from that moment
underlying the Lifecycle.
Calibration status in all Lifecycle Template "Unregulated, ER, ERES":
Allowed Lifecycle functions are visible, the grey fields are not available.
Note: Audit trail will log all important transitions.