Hardy HI 1746-WS - Manual (Page 31)

Chapter 4 - Setup
4-1
CHAPTER 4 - SETUP
A Brief Description of
Chapter 4 All information contained in Chapter 4 pertains to
firmware and software settings (Local and Remote
modes of operation) to prepare the module controller
for calibration and operation. Alternatives to these
procedures explicit or implied, contained in this sec-
tion are not recommended. It is very important that
the user and service personnel be familiar with the
procedures contained in this chapter, before going
through the setup procedures. The Setup procedures
require either Allen-Bradley DOS PLC 500 AI Series
Ladder Logic Editor, Allen-Bradley RS Logix 500,
Allen-Bradley RSLinx™ or RSLinx™ Lite. The
Local Mode of Operation means the Module is
installed in a SLC Chassis and Remote Mode of Oper-
ation means the Module is installed in a Remote
Chassis.
Power Check Step 1. Check to see that there is power to the
SLC and the module.
Step 2. If there is power to the module, the LEDS
should be lit. (See Fig. 4-1)
Step 3. To make any settings the LED’s should be
lit as follows:
a. Run/Fault - Steady Green
b. Communication - Flashing Green
c. C2 - Steady Green if system has C2
load cells or off if there are no C2 load
cells.