Leds, Run/fault led, Comm. led – Hardy HI 1746-WS User Manual
Page 32: C2 led, Leds -2, Run/fault led -2 comm. led -2 c2 led -2, Setting up communications between the slc and the, Module leds -2
HI 1746-WS WEIGH SCALE MODULE
4-2
FIG. 4-1 MODULE LEDS
LEDS
Run/Fault LED
Flashing Green Self-Test is running.
Flashing Green (5Hz Flash Speed) - Self-Test
Failed, or no calibration.
Steady Green
Self-Test Passed
Flashing Red
Weigh Scale Module has a fault.
Steady Red
Module has a major problem.*
NOTE:
* Contact Hardy Customer Support for assistance.
Comm. LED
Steady Green
Normal Operation
Flashing Green
Block transfer is being performed.
LED is Off
No Communication
C2 LED
Steady Green
A C2 load cell(s) has been found.
LED is Off
No C2 load cells have been found.
Steady Red
Unable to read loadcell data or the
loadcell data is in error.
Setting Up
Communications
Between the SLC and
the HI 1746-WS Weigh
Scale Module
To set up communication between the SLC 5XX and
the HI 1746-WS Weigh Scale Module you will need
to select or enter the following information into the I/
O Configuration section of your software: