Hardy HI 1746-WS - Manual (Page 58)

HI 1746-WS WEIGH SCALE MODULE
4-28
Error Code List SUCCESS 0
NOTALLOWED -1
OUTOFTOLERANCE -3
INDEXOUTOFRANGE -4
NOSUCHCMD -5
C2FAILNODEVS -6
C2FAILCAPEQ -7 (failure, capacities
not equal)
HARCALFAILCOUNTS -8 (failure, not enough
ADC counts between
high, low)
NOTE: For a complete ladder logic example for downloading
all the parameters please go to the Hardy Process
Solutions Inc. Web Site at: www.hardysolutions.com.
Select Support then click on Sample Programs. If you
do not have access to the Internet contact your local
Hardy Representative or Hardy Customer Support
and we will be glad to fax or mail you a hard copy.
Calibration Setup
Procedures
Setting the Unit of
Measure The Unit of measure (Metric - See Table 4-1) can be
set to either kilograms or pounds. Any weight value
input to the module (e.g. CAL-LO, CAL-HI setpoints)
are in the currently selected units. The unit of measure
can be set at any time, not just at calibration. Setting
the unit of measure before calibrating reminds the
user what unit of measure is being displayed. It is
important to note that the weigh scale module does
not need to be calibrated again after changing the unit
of measure.
Setting the Motion
Tolerance Value The motion tolerance is the tolerance value used to
determine if the scale is in motion.
Calid (int) 0xA2
Parameter (type) Offset (Hex)
Table 4-1: Parameters and Offsets