26 self-diagnosis on/off setting, Toshiba – Toshiba LF600F User Manual
Page 102
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TOSHIBA
i6|F,8,A0,8|6|9|
8.2.26 Self-diagnosis ON/OFF Setting
You can set the self-diagnosis function to be "enabled" or "disabled."
If the self-diagnosis function is disabled, no error message is displayed even if any of the errors listed
below occurs.
• ROM defect
• RAM defect
• Own parameter error
• Excitation cable is not connected or it is disconnected
• Excitation circuit fault
• ADC circuit fault
• Total data destroy
Selection item
Description
OFF
Self-diagnosis function is disabled.
ON
Self-diagnosis function is enabled.
Error message is displayed in measurement sub screen.
Changing the self-diagnosis function setting
wn below is an example of changing the se f-diagnosis setting from
OFF
to
ON.
Key operation
Display example
Description
K:
Select "SELF CHECK" in the configuration item selection
MEAS MODE
EMPTY ALM
^SELF CHECK
ALM PRESET
iSELl [ENTI
screen.
STEP1
K2:
The current setting value (OFF in this example) is
SELF CHECK
OFF
displayed.
[ENT]
Then press the [ENT] key.
fEXTl [ENTI
* Pressing the [EXT] key returns you to the menu screen.
STEP2
K2:
The switch name display at the bottom changes (three
SELF CHECK
keys [UP], [DWN] and [SET]).
Maa
At the same time, the cursor appears.
[ENT]
(The digit on which the cursor is positioned is
[U P] [DWNl [SET]
reverse-displayed.)
STEPS
K2:
SELF CHECK
Change the selection item using the [UP]/[DWN] key.
When you have selected the desired item, press the [SET]
[UP]/[DWN]
[U P] [DWNl [SETI
key.
STEP4
K2:
When you press the [SET] key, the selected item is set
SELF CHECK
temporarily and a message confirming you whether the
ON
setting is OK is displayed.
[SET]
If OK, press the [SET] key. If you want to redo the setting.
OK? ^
[N Ol [SETI
press the [NO] key.
STEP5-1
K2:
Pressing the [NO] key when you are asked "OK?" causes
SELF CHECK
the setting value to return to the previous value and
[NO]
wag
[U P] [DWNl [SET!
enables you to redo the setting.
STEP5-2(=END)
K2:
Pressing the [SET] key when you are asked "OK?" causes
SELF CHECK
the setting to be determined.
ON
Then press the [EXT] key. You return to the menu screen.
[SET]
[EXTl [ENTI
Pressing the [ENT] key enables you to restart setting
operation from a state of ON.
-
101
-