Toshiba LF600F - Manual (Page 83)

TOSHIBA i6,F,8,A0,8,6,9,
Changing the hysteresis
The hysteresis is set to 3% at factory, unless otherwise specified.
Shown below is an example of changing the hysteresis from 3% to 5%.
Key operation Display example Description
C6: Select "RANGE HYS" in the configuration item
RANGE HYS selection screen.
03.0
The currently set hysteresis (3.0% in this example)
%
is displayed.
ÌEXT1 [ENTI
Then press the [ENT] key.
STEP1 C6: The switch name display at the bottom changes
RANGE HYS (three keys [UP], [SEL] and [SET])
gp.o
At the same time, the cursor appears.
[ENT]
%
[U P] [SEL] [SET]
(The digit on which the cursor is positioned is
reverse-displayed.)
STEP2 C6: Move the cursor to the desired digit using the [SEL]
RANGE HYS key and change the numeric value using the [UP]
OS-O
key.
[SEL]<^[UP]
%
Repeat this operation to change the value to 5.0%.
[U P] [SEL] [SET]
When the setting has changed to the desired
numeric value, press the [SET] key to set the
hysteresis temporarily.
STEP3 C6: When you press the [SET] key, a message
RANGE HYS confirming you whether the setting is OK is
05.0
displayed.
[SET]
%
If OK, press the [SET] key. If you want to redo the
OK? ^
IN 01 [SETI
setting, press the [NO] key.
STEP4-1 C6: Pressing the [NO] when you are asked "OK?"
RANGE HYS causes the span hysteresis to return to the previous
03.0
setting and enables you to redo the setting.
[NO]
' %
[U PI [SELl [SETI
STEP4-2(=END) C6: Pressing the [SET] key when you are asked "OK?"
RANGE HYS causes the setting to be determined.
05.0 Then press the [EXT] key. You return to the menu
[SET]
%
screen.
Pressing the [ENT] key enables you to restart
[EXTl [ENTI
hysteresis change operation from a state of 5.0%.
Note If you set a value exceeding 25.0%, *HIGH OVER SPEC.* is displayed and the setting
returns to the one before change. Set a value once again.
-
82
-