Toshiba LF600F - Manual (Page 80)

TOSHIBA 6,F|8iA0|8,6,9|
To change the range type:
Range type should be changed before changing the span.
The following example shows how to change the range type from the single range (SFNGLE) to
bi-directional internal signal selection multi-range (2F-2R).
Key operation I Display example Description
I C1: Select "RANGE TYPE" in the configuration item
RANGE TYPE selection screen.
SINGLE
The currently set range type (SINGLE in this
example) is displayed.
[EXT] [ENT]
Then press the [ENT] key.
STEP1 C1: The switch name display at the bottom changes
I RANGE TYPE (three keys [UP], [DWN] and [SET]).
SINGLE
At the same, the cursor appears.
[ENT] (The digit on which the cursor is positioned is
reversed-displayed.)
[U PJ [DWN] [SET]
STEP2 I C1: Change the selection item using the [UP]/[DWN]
RANGE TYPE key.
[UP]/[DWN] When the selection item has changed to the desired
item, press the [SET] key.
I [U PI fDWNl fSETl I
STEP3 I C1: When you press the [SET] key, the item you have
RANGE TYPE selected is set temporarily and a message
2F-2R
confirming you whether the setting is OK is
[SET]
4
OK? '■
[NO]
f
[SET]
displayed.
If OK, press the [SET] key. If you want to redo the
setting, press the [NO] key.
STEP4-1 C1: Pressing the [NO] key when you are asked "OK?"
I RANGE TYPE returns the range type setting to the previous setting
and enables you to redo the setting.
SINGLE
[NO]
[U P] [DWN] [SET]
STEP4-2(=END) I C1: Pressing the [SET] key when you are asked "OK?"
RANGE TYPE causes the setting to be determined.
2F-2R
Then, press the [EXT] key. You return to the menu
[SET] screen.
[EXT] [ENT]
Pressing the [ENT] key enables you to restart
switch range type setting from the position setting
from a state of 2F-2R.
-
79
-