7 remote selection of fixed value output, Toshiba, 6,f|8 – Toshiba LF600F User Manual
Page 132
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TOSHIBA
6,F|8
i
A0
i
8,6|9,
10.7 Remote Selection of Fixed Value Output
A user-specifled 4-20 mA output and pulse output can be selected with a DI signal.
Proceed as follows to use this function:
Fixed-value setting
Set the fixed-value for current output and for pulse output. See 0, “Fixed-Value
Output.” Set the fixed-value output enable/disable status to “OFF.”
If the pulse output is not used, fixed-value setting for pulse output is not
needed.
DI function setting
Set DI to use as a fixed-value output control signal. See 0, “Digital I/O.”
Control signal input conditions:
Control signal input level
4 -20 mA and pulse output
L level
Outputs the measured value.
H level
Outputs the fixed-value.
-
131
-