Toshiba LF600F - Manual (Page 111)

TOSHIBA 6F,8A08 6.9
8.2.31 Parameter initial settings list
Parameter name Initial setting value
Exciting current Adjusted value when the product is shipped from the factory
(described on the detector nameplate)
Meter size Value requested when ordered.
Exciting frequency 24Hz
* When meter size is 250 to 450mm: 12Hz
When meter size is 500 or 600mm: 6Hz
Flow direction NORMAL
Password 000
Address setting 126
Main display setting qal/min
Sub display setting COUNT В
Custom (coefficient) 0
Custom (unit) " “(7 characters are all blank spaces)
LCD density 3
Switch position BOTTOM (screen bottom)
Range type Value requested when ordered
Range 1 to Range 4 Value requested when ordered
Hysteresis 3.0 %
Damping constant 5.0 s
Low cut value 1.0%
Output setting at alarm occurrence 4mA output
Display low cut OFF
Output low limit setting 4mA
Digital output 1 PULSE OUT (Pulse output)
Digital output 2 EMPTY ALM (Empty alarm output)
Digital input C RES/STA (Counter reset/start)
Digital output 1 status NORMAL OPEN
Digital output 2 status NORMAL OPEN
Digital input detection level HIGH LEVEL
Count rate 100 gal
Pulse width setting mode MANUAL
Pulse width 5 ms
Preset count value 00000000
Preset output function HOLD
High limit alarm setting OFF
High limit value 0.0 %
Low limit alarm setting OFF
Low limit value 0.0 %
High high limit alarm setting OFF
High high limit value 0.0 %
Low low limit alarm setting OFF
Low low limit value 0.0 %
Fluid empty alarm ON detection: NORMAL
Self-disgnosis function ON
Alarm output preset WITHOUT EMP (excluding the fuild empty alram)
Rate-of-change limit 0.0 %
Control time Os
Fixed output function OFF
Manual zero 0.0 %
Note 1: Parameters specified separately when ordered are set as instructed.
Note 2: If an option board is not provided, Digital output 2 and Digital input functions do not work.
-
110
-