Toshiba LF600F - Manual (Page 51)

TOSHIBA 6.F,8|A0,8,6,9,
7.4 Configuration items Seiection Tabie
The check/change menu for each constant to be set for the converter is expanded as shown in the table
below.
Details of each item are described in the configuration items (A to M) in Chapter 8 "Configuration
Parameter Setting."
OBasic configuration (when the menu configuration is BASIC)
When you select "BASIC" in the menu configuration selection screen, the check/change menu for each
constant setting is expanded as shown in the table blow.
0 1 2 3
B
Return to the
measurement mode
Main display setting Sub display setting
c
Range type Range 1
D Damping constant Low cut value
F Digital output 1 Digital output 2 Digital input 1
G Count rate
Pulse width
Setting mode
Pulse width
When the operation mode is switched from the measurement mode to the setting mode, group B is
displayed first in the case of basic configuration. ^
After that, the screen changes as follows:
Group B (start screen) ^ Group C O Group D <=> Group F Group G ^ Group B
^:When the [U P] key is pressed (the group is incremented).
:When the [DWN] key is pressed (the group is decremented).
-
50
-