Comtrol eCos - Manual (Page 192)

Chapter 5. Installation and Testing
Rebuilding RedBoot
These shell variables provide the platform-specific information needed for building RedBoot according to the
procedure described in
Chapter 3 :
export TARGET=asb2305
export ARCH_DIR=mn10300
export PLATFORM_DIR=asb2305
The names of configuration files are listed above with the description of the associated modes.
ARM/ARM7 ARM Evaluator7T
Overview
RedBoot supports both serial ports for communication and downloads. The default serial port settings are
38400,8,N,1.
The following RedBoot configurations are supported:
Configuration Mode Description File
ROM [ROM] RedBoot running from
flash address 0x20000,
with ARM Boot Monitor in
flash boot sector. redboot_ROMA.ecm
Initial Installation
RedBoot is installed using the on-board boot environment. See the user manual for full details.
Quick download instructions
Here are quick start instructions for downloading the prebuilt Redboot image:
• Boot the board and press ENTER:
ARM Evaluator7T Boot Monitor PreRelease 1.00
Press ENTER within 2 seconds to stop autoboot
Boot:
• Erase the part of the flash where RedBoot will get programmed:
Boot: flasherase 01820000 10000
88