Special redboot commands, Memory maps – Comtrol eCos User Manual
Page 195
Chapter 5. Installation and Testing
ARM bootPROM [Version 1.3] Rebuilt on Jun 26 2001 at 22:04:10
Running on a Integrator Evaluation Board
Board Revision V1.0, ARM966E-S Processor
Memory Size is 16MBytes, Flash Size is 32MBytes
Copyright (c) ARM Limited 1999 - 2001. All rights reserved.
Board designed by ARM Limited
Hardware support provided at http://www.arm.com/
For help on the available commands type ? or h
boot Monitor >
•
Issue the FLASH ROM load command:
boot Monitor > L
Load Motorola S-Records into flash
Deleting Image 0
The S-Record loader only accepts input on the serial port.
Type Ctrl/C to exit loader.
•
Either use the ASCII transmit option in the terminal emulator, or on Linux, simply cat the file to the serial port:
$ cat redboot.srec > /dev/ttyS0
When complete, type Ctrl-C and you should see something similar to:
................................
................................
....................
Downloaded 5,394 records in 81 seconds.
Overwritten block/s
0
boot Monitor >
•
Set DIP switch S1[1] to the OFF position and reboot the board and you should see the RedBoot banner.
Special RedBoot Commands
None.
Memory Maps
RedBoot sets up the following memory map on the Integrator board.
NOTE: The virtual memory maps in this section use a C and B column to indicate whether or not the region is
cached (C) or buffered (B).
91