Comtrol eCos - Manual (Page 214)

Chapter 5. Installation and Testing
ARM/StrongARM(SA1110) Intel SA1110 (Assabet)
Overview
RedBoot supports the board serial port and the compact flash ethernet port. The default serial port settings are
38400,8,N,1. RedBoot also supports flash management on the Assabet.
The following RedBoot configurations are supported:
Configuration Mode Description File
ROM [ROM] RedBoot running from the
board’s flash boot sector. redboot_ROM.ecm
RAM [RAM] RedBoot running from
RAM with RedBoot in the
flash boot sector. redboot_RAM.ecm
Initial Installation Method
A Windows or Linux utility is used to program flash over parallel port driven JTAG interface. See board documen-
tation for details on in situ flash programming.
The flash parts are also socketed and may be programmed in a suitable device programmer.
Special RedBoot Commands
None.
Memory Maps
The first level page table is located at physical address 0xc0004000. No second level tables are used.
NOTE: The virtual memory maps in this section use a C and B column to indicate whether or not the region is
cached (C) or buffered (B).
Physical Address Range Description
----------------------- ----------------------------------
0x00000000 - 0x07ffffff flash
0x08000000 - 0x0fffffff SA-1111 Board flash
0x10000000 - 0x17ffffff Board Registers
0x18000000 - 0x1fffffff Ethernet
0x20000000 - 0x2fffffff SA-1111 Board PCMCIA
0x30000000 - 0x3fffffff Compact Flash
0x40000000 - 0x47ffffff SA-1111 Board
0x48000000 - 0x4bffffff GFX
0x80000000 - 0xbfffffff SA-1110 Internal Registers
110