Comtrol eCos - Manual (Page 199)

Chapter 5. Installation and Testing
to flash.
arm-elf-gdb redboot_RAM.elf
(gdb) tar rdi s=/dev/ttyS0
Angel Debug Monitor (serial) 1.04 (Advanced RISC Machines SDT 2.5) for
AT91EB40 (2.00)
Angel Debug Monitor rebuilt on Apr 07 2000 at 12:40:31
Serial Rate: 9600
Connected to ARM RDI target.
(gdb) set $cpsr=0xd3
(gdb) load
Loading section .rom_vectors, size 0x40 lma 0x2020000
Loading section .text, size 0x7fd8 lma 0x2020040
Loading section .rodata, size 0x15a0 lma 0x2028018
Loading section .data, size 0x2e4 lma 0x20295b8
Start address 0x2020040 , load size 39068
Transfer rate: 6250 bits/sec, 500 bytes/write.
At this point, set SW1 to "upper mem".
(gdb) cont
Continuing.
At this point, suspend the GDB session (use Ctrl-Z) and start a terminal emulator:
RedBoot> version
RedBoot(tm) bootstrap and debug environment [RAM]
Non-certified release, version UNKNOWN - built 14:09:27, Jul 20 2001
Platform: Atmel AT91/EB40 (ARM7TDMI)
Copyright (C) 2000, 2001, Red Hat, Inc.
RAM: 0x02000000-0x02080000, 0x020116d8-0x0207fd00 available
FLASH: 0x01010000 - 0x01020000, 256 blocks of 0x00000100 bytes each.
RedBoot> load -m ymodem -b %{FREEMEMLO}
Use minicom to send the file redboot_ROMRAM.srec via YModem.
RedBoot> fi wr -f 0x01010000 -b %{FREEMEMLO} -l 0xe100
Press the "reset" pushbutton and RedBoot should come up on the board.
Special RedBoot Commands
None.
95