Command line interface introduction – Comtrol ES7528 User Manual
Page 142
142 - Command Line Interface Introduction
RocketLinx ES7528 User Guide: 2000509 Rev. C
Configuration Using the Command Line Interface (CLI)
If you selected SSH, click Yes.
•
Enter the user name (default = admin).
•
Enter the password (default = admin).
If you selected Telnet:
•
Enter the user name (default = admin).
•
Enter the password (default = admin).
All the commands you see in SSH are the same as the CLI commands you see through the RS-232 console.
For more information about using the CLI, see
Command Line Interface Introduction
Command Line Interface Introduction
The Command Line Interface (CLI) is the user interface to the ES7528 embedded software. You can view the
system information, show the status, configure the switch, and receive a response back from the system by
keying in a command.
There are several different command modes. Each command mode has its own access ability, available
command lines and uses different command lines to enter and exit. These modes are:
•
on Page 143, which includes commands to ping or telnet to a remote device, and show
some basic information and to access Privileged EXEC mode
•
on Page 145, which provides a view current configuration, reset default, reload
switch, show system information, save configuration, and access Global Configuration mode
•
on Page 146, which you can use configure all ES7528 features and access to
one of the Interface Configuration modes
•
(Port) Interface Configuration
on Page 147, which can be used to configure port settings
•
(VLAN) Interface Configuration
on Page 148, which can be used to configure the settings for a specific
VLAN
Refer to