User exec mode, Accessing the options for a command – Comtrol ES7528 User Manual
Page 143
RocketLinx ES7528 User Guide: 2000509 Rev. C
User EXEC Mode - 143
Configuration Using the Command Line Interface (CLI)
User EXEC Mode
When you login to the ES7528 with the CLI, you are in User EXEC mode.
In User EXEC mode, you
can ping, telnet to a remote
device, and show some basic
information.
Type the command and
press Enter:
•
enable to access
Privileged EXEC mode
(
•
exit to logout.
•
? to see the command
list.
•
list to review the User EXEC mode commands and corresponding options.
For the complete list of commands with options, refer to
Accessing the Options for a Command
The following example illustrates how to view the description and options for a command. This example
illustrates the show command and the firmware version displayed may not reflect your firmware version.
Note: The ? does not appear on the screen.
1.
If you type show? (without a space between show and the ?; do not press the Enter key) the ES7528
provides a basic description of that command.
2.
If you type show ? (with a space between show and the ?; do not press the Enter key) the ES7528 provides
information about the options for that command.
3.
Type show ip ? (with a space between show and the ?, do not press the Enter key) to review the options for
ip.
Switch>
enable Turn on privileged mode command
exit Exit current mode and down to previous mode
list Print command list
ping Send echo messages
quit Exit current mode and down to previous mode
show Show running system information
telnet Open a telnet connection
traceroute Trace route to destination
Switch login: admin
Password:
Switch (version 2.7 -20130314 - 15:23:41)
switch> show
show Show running system information
Switch> show
gvrp GARP VLAN Registration Protocol
ip IP information
version Displays ISS version
Switch> show
Switch> show ip
forwarding IP forwarding status
route IP routing table