Comtrol ES7528 User Manual
Page 75
RocketLinx ES7528 User Guide: 2000509 Rev. C
PoE Control - 75
Configuration Using the Web Interface
You can use these steps to configure PoE settings. Refer to the following table if you need more detailed
information.
1.
Select Enable in the PoE System drop list.
2.
Enter appropriate values for the DC1 and/or DC2 power budgets.
3.
Optionally, set a Power Budget Warning Level so that the ES7528 sends a warning event. See
on Page 127 for more information.
4.
Click Apply.
5.
Select Enable for the port or ports that you want to
use as PoE ports.
6.
Select the appropriate PoE Mode (Enable, Disable, or
Schedule) for the appropriate ports.
Note: If you select Schedule, you must also configure
the port or ports using
7.
Select the appropriate Powering Mode (802.3af,
802.3at(LLDP), 802.3at(2 event), or Force for the PD
that you plan on attaching to the corresponding
port.
8.
Enter a valid Power Budget for the port based on the
attached power supply, if you selected Manual Mode
for the Port Configuration Power Budget.
9.
Select an appropriate Power Priority (Critical, High,
or Low).
10. Click Apply.
11. If desired, set up PD Status Detection.
12. You must Save the settings (
), if you want
maintain these settings if the ES7528 is powered
off.