Comtrol ES7528 - Manual (Page 161)

RocketLinx ES7528 User Guide: 2000509 Rev. C Power over Ethernet (CLI) - 161
Configuration Using the Command Line Interface (CLI)
Power over Ethernet (CLI)
Power over Ethernet is one of the key features of ES7528. It is fully IEEE 802.3af compliant, and supports
IEEE 802.3at, including two-event and LLDP classification. The ES7528 supports up to 24-Port PoE injectors
in Port 1 to Port 24, each port with the ability to deliver 606 mA current.
For more information or to use the web user interface, see Power over Ethernet on Page 74.
This table provides detailed information about the CLI commands for PoE control.
PoE System Status
Display
Switch> enable
Switch# show poe system
PoE System
PoE Admin : Enable
PoE Hardward : Normal
PoE Input Voltage :
Vmain 1 : 52.9 V
Vmain 2 : 53.0 V
Vmain 3 : 53.1 V
Output power : 0.0 Watts
Temperature 1 : 50 degree
Temperature 2 : 53 degree
Temperature 3 : 48 degree
Power information :
Emergency power :
Primary : DC1(53 V), DC2(53 V), AC(53 V)
Secondary : N/A
Tertiary : N/A
Budget :
DC Power 1 : 400 Watts
DC Power 2 : 400 Watts
AC Power : 300 Watts (In Use)
Total : 300 Watts in Use
Warning water level : N/A
Utilization : 0 %
Event : Normal
PoE Interface Status
PoE PD Detection
Status
Switch# show poe pd-detect
PD Status Detection
Status : Enabled
Host 1 :
Target IP : 192.168.250.100
Cycle Time : 10
Host 2 :
Target IP : 192.168.250.200
Cycle Time : 20