Comtrol ES7528 - Manual (Page 157)

RocketLinx ES7528 User Guide: 2000509 Rev. C Port Configuration (CLI) - 157
Configuration Using the Command Line Interface (CLI)
Port Configuration (CLI)
The Port Configuration group allows you to enable/disable port state, or configure port auto-negotiation,
speed, duplex, flow control, rate limit control, and port aggregation settings. It also allows you to view port
status and aggregation information.
Optionally, you can use the web user interface for configuration, see Port Configuration on Page 66.
This table provides detailed information about the CLI commands for port configuration.
Port Control
Port Control
– State
Switch(config-if)# shutdown -> Disable port state
Port1 Link Change to DOWN
interface fastethernet1 is shutdown now.
Switch(config-if)# no shutdown -> Enable port state
Port1 Link Change to DOWN
Port1 Link Change to UP
interface fastethernet1 is up now.
Switch(config-if)# Port1 Link Change to UP
Switch(config)# sfp
ddm Digital diagnostic and monitoring
Switch(config)# sfp ddm
Eject Reject DDM SFP
Switch(config)# sfp ddm eject
 eject SFP DDM transceiver
all All DDM interface
Example: Switch(config)# sfp ddm eject all
DDM SFP on Port 9 normally ejected.
DDM SFP on Port 9 normally ejected.
All DDM SFP normally ejected.
Switch(config)# interface gigabitethernet10
 eject port 10 SFP DDM
transceiver.
Switch(config-if)# sfp ddm eject
DDM SFP on Port 9 normally ejected.
Port Control
– Auto
Negotiation Switch(config)# interface fa1
Switch(config-if)# auto-negotiation
Auto-negotiation of port 1 is enabled!
Port Control
– Force
Speed/
Duplex
Switch(config-if)# speed 100
Port1 Link Change to DOWN
set the speed mode ok!
Switch(config-if)# Port1 Link Change to UP
Switch(config-if)# duplex full
set the duplex mode ok!