Futaba 8FG 2.4GHz - Manual (Page 105)

105 0RGHO0HQX $LUSODQH*OLGHU)XQFWLRQV !
ŏ6HOHFW WKH IXQFWLRQ QDPH
and return to the Model
menu by touching the
RTN button.
<SensorTouch™>
RUD to ELE [Corresponding model type]: Airplane, general
7KLV IXQFWLRQ LV XVHG ZKHQ \RX ZDQW WR PL[
HOHYDWRURSHUDWLRQZLWKUXGGHURSHUDWLRQ,WLVXVHG
WRFRUUHFWXQGHVLUDEOHWHQGHQFLHVZKHQUXGGHULV
DSSOLHGLQUROOLQJPDQHXYHUVVXFKDVNQLIHHGJH
ÀLJKW
ŏ 0L[LQJ GXULQJ IOLJKW FDQ EH WXUQHG 212)) E\
setting a switch. (Always ON at [--] setting)
ŏ /LQN PL[LQJ FDQ EH VHW /LQNV WKLV PL[ WR RWKHU PL[HV
ŏ 6HOHFW >58' WR (/(@ DW WKH 0RGHO
menu and access the setup screen
shown below by touching the RTN
button.
Scrolling
ŏ0RYLQJ FXUVRU
ŏ6HOHFWLQJ PRGH
ŏ$GMXVWLQJ YDOXH
ŏ7R QH[W SDJH
6HWWLQJPHWKRG
Ɣ$FWLYDWHWKHIXQFWLRQ
Move the cursor to the [ACT] item and touch
the RTN button to switch to the data input
mode. Select the ACT mode by scrolling the
touch sensor.
*The display blinks.
T o u c h t h e R T N b u t t o n t o a c t i v a t e t h e
function and return to the cursor mode. (ON
is displayed.)
When selecting a switch, move the cursor to
the [SW] item and touch the RTN button to
call the selection screen. Select the switch
and set its ON direction. (Always ON at "--"
setting)
)RUDGHVFULSWLRQRIWKHVZLWFKVHOHFWLRQPHWKRGVHHWKH
description at the back of this manual.
Ɣ0L[LQJUDWHDGMXVWPHQW
Move the cursor to the left or right item
and touch the RTN button to switch to the
data input mode. Adjust the mixing rate
independently by scrolling the touch sensor.
,QLWLDO YDOXH 
$GMXVWPHQW UDQJH a
:KHQWKH571EXWWRQLVWRXFKHGIRURQHVHFRQGWKHUDWHLV
UHVHWWRWKHLQLWLDOYDOXH
Touch the RTN button to end the adjustment
and return to the cursor mode.
Ɣ/LQNPRGHVHWWLQJ
When selecting the link mixing, move the
cursor to the [LINK] item and touch the RTN
button to switch to the data input mode.
Select the ON mode by scrolling the touch
sensor.
*The display blinks.
Touch the RTN button to set the link mode
and return to the cursor mode.