Futaba 8FG 2.4GHz - Manual (Page 58)

58 )XQFWLRQVRI/LQNDJH0HQX!
ŏ6HOHFW WKH IXQFWLRQ QDPH
and return to the Linkage
menu by touching the
RTN button.
<SensorTouch™>
SUB-TRIM Setting of neutral position of each servo.
7KHGLVSOD\VFUHHQLVDQH[DPSOH7KH
VFUHHQGHSHQGVRQWKHPRGHOW\SH
The Sub-Trim function is used to set the servo
QHXWUDO SRVLWLRQ DQG PD\ EH XVHG WR PDNH ILQH
DGMXVWPHQWV WR WKH FRQWURO VXUIDFH DIWHU OLQNDJHV
and pushrods are hooked up. When you begin to set
XSDPRGHOEHVXUHWKDWWKHGLJLWDOWULPVDUHVHWWR
their center position.
6XEWULPDGMXVWPHQW
1. Move the cursor to the channel you want to
adjust and touch the RTN button to switch to
the data input mode.
2. Adjust the rate by scrolling the touch sensor.
Initial value: 0
Adjustment range: -240~+240 (steps)
:KHQWKH571EXWWRQLVWRXFKHGIRURQHVHFRQGVXEWULPLV
UHVHWWRWKHLQLWLDOYDOXH
%HIRUHVXEWULPDGMXVWPHQWLWLVYHU\LPSRUWDQWWRDGMXVWWKH
linkages at the control surface so that you do not use sub-
WULPH[FHSWIRUYHU\PLQXWHDGMXVWPHQWV
3. Touch the RTN button to end adjustment and
return to the cursor mode.
4. Repeat this procedure for each channel.
ŏ 6HOHFW >68%75,0@ LQ WKH /LQNDJH PHQX DQG DFFHVV
the setup screen shown below by touching the
RTN button.
Scrolling
ŏ0RYLQJ FXUVRU
ŏ$GMXVWLQJ YDOXH