Futaba 8FG 2.4GHz - Manual (Page 57)

57 )XQFWLRQVRI/LQNDJH0HQX!
7ULPVHWWLQJ
Move the cursor to the "TRIM" item of the
channel you want to change and touch the
RTN button.
*The trim setup screen is displayed.
The following items can be set at the trim
setup screen:
7ULPVHOHFWLRQ
Move the cursor to the trim, lever, etc. you
want to set and touch the RTN button.
*The setting can be changed.
7ULPUDWHVHWWLQJ
Move the cursor to the [RATE] item and
touch the RTN button to switch to the data
input mode.
Set the trim rate by scrolling the touch sensor.
,QLWLDO YDOXH 
$GMXVWPHQW UDQJH a
:KHQWKH571EXWWRQLVWRXFKHGIRURQHVHFRQGWKHWULP
UDWHLVUHVHWWRWKHLQLWLDOYDOXH
Touch the RTN button to end adjustment and
return to the cursor mode.
7ULPPRGHVHOHFWLRQ
Move the cursor to the [MODE] item and
touch the RTN button to switch to the data
input mode.
Select the trim mode by scrolling the touch
sensor. A confirmation message appears.
Touch the RTN button to change the mode.
(To terminate input and return to the original
state, touch the S1 button.)
[NORM]: Normal mode. Normal trim (parallel
shift trim) operation.
[ A T L ] : A T L o p e r a t i o n m o d e . M a x i m u m
change near idle or low-stick position,
normally used with throttle trim. It is also
possible to reverse the travel.
>1250$/@>5(9(56@VHOHFWLRQLVSRVVLEOHDWWKH$7/
item.
&KDQQHOUHSODFHPHQW
Move the cursor to the channel # you want
to replace and touch the RTN button to
switch to the data input mode.
Select the destination channel # by scrolling
the touch sensor. A confirmation message
appears. Touch the RTN button to replace
the channel. (To terminate input and return
to the original state, touch the S1 button.)