Futaba 8FG 2.4GHz - Manual (Page 25)

25 %DVLF2SHUDWLRQ!
2SHUDWLRQ0RGH6HOHFW 5+6
7KHUHFHLYHURSHUDWLRQPRGHLVRQ1RUPDOPRGHIURPIDFWRU\VKLSSLQJ7RFKDQJHWKHPRGHSOHDVH
DGKHUHWRWKHIROORZLQJVWHSV
&KDQJLQJWKHRSHUDWLRQPRGH
LED
Link/Mode Button
1. Turn off the receiver.
2. Press and hold the Link/Mode button and
turn on the receiver. Continue holding the
button for more than one(1) second. The LED
EHJLQV ÁDVKLQJ WR LQGLFDWH WKH FXUUHQW VWDWXV
3. Release the button.
4. Turn off the receiver.
%\GRLQJVRWKHUHFHLYHUZLOOFKDQJHPRGHV
&RQ¿UPLQJWKHRSHUDWLRQPRGH
Please check the operation mode by observing
WKH/('ZKHQWXUQLQJRQWKHUHFHLYHU
If possible ensure that there's no FASST
transmitter in operation near the receiver.
1. When the receiver is turned on:
Red when on "Normal mode"
Initially flashes green and Red (making
Orange) when in "High Speed mode". After
two(2) seconds, change to Red.
If there are additional FASST transmitters turned
RQQHDUWKHUHFHLYHUWKH/('PD\VKRZWKHDERYH
status for a brief moment before changing to the
VWDWXVLQGLFDWLRQDVVKRZQLQWKH/('LQGLFDWLRQ
WDEOHEHORZ
/(',QGLFDWLRQ 5+6
Green Red Status
Off Solid No signal reception
Solid Off Receiving signals
Blink Off
Receiving signals but ID is
unmatched
0 to 1 sec. More than 1 sec.
0 sec. 1 sec.
Press and Hold time
Turn on the receiver.
No function
Showing the CURRENT
mode with blink.
Red Blink = Normal
Green/Red Blink =
High Speed
Solid as the mode changed.
Red Solid = Normal
Green/Red Solid = High
Speed
(Become Red after one (1)
second)
㧔Function㧕
To change the mode between
Normal and High Speed
㧔LED Status㧕
2SHUDWLRQ0RGH6HOHFW