Futaba 8FG 2.4GHz - Manual (Page 115)

115 )XQFWLRQVRI0RGHO0HQX +HOLFRSWHU)XQFWLRQV !
ŏ6HOHFW WKH IXQFWLRQ QDPH
and return to the Model
menu by touching the
RTN button.
<SensorTouch™>
6:$6+0,;
7KHVZDVKPL[IXQFWLRQLVXVHGWRFRUUHFWWKH
VZDVK SODWH LQ WKH DLOHURQ UROO  GLUHFWLRQ DQG
HOHYDWRU F\FOLF SLWFK  FRUUHVSRQGLQJ WR HDFK
operation of each condition.
7KLV IXQFWLRQ DOORZV WKH LQGHSHQGHQW UDWH
DGMXVWPHQWVIRUWKHDLOHURQVHOHYDWRUDQGSLWFK
([DPSOHRIXVH
ŏ $V DQ H[DPSOH XVH VZDVK PL[LQJ WR FRUUHFW
undesirable roll tendencies.
ŏ )RU D FRQGLWLRQ ZKLFK XVHV $,/ WR (/( VHW WKLV
function to ON.
If the front of the helicopter raises during a
right roll, when the Rate 2 side is input and
the right aileron is operated, the elevator
moves to the down side. Tune by adjusting
the Rate.
6HWWLQJPHWKRG
Ɣ$FWLYDWHWKHPL[LQJ
When using this function, move the cursor to
the [ACT] item and touch the RTN button to
switch to the data input mode.
Select the ACT mode by scrolling the touch
sensor.
*The display blinks.
Touch the RTN button to activate the mixing
and return to the cursor mode. (ON is
displayed.)
[Switch selection]
When [ [--]] is set, the swash mixing function is
operated by merely selecting the condition.
When setting an [ON]/[OFF] switch, move the
cursor to the [SW] item and touch the RTN
button to access the selection screen. Set
the switch and its ON position.
)RUDGHVFULSWLRQRIWKHVZLWFKVHOHFWLRQPHWKRGVHHWKH
description at the back of this manual.
Ɣ0L[LQJUDWHDGMXVWPHQW
Move the cursor to the mixing rate item you
want to correct and touch the RTN button
to switch to the data input mode. Adjust the
rate independently by scrolling the touch
sensor.
,QLWLDO YDOXH 
$GMXVWPHQW UDQJH a
:KHQWKH571EXWWRQLVWRXFKHGIRURQHVHFRQGWKHUDWHLV
UHVHWWRWKHLQLWLDOYDOXH
Touch the RTN button to end the adjustment
and return to the cursor mode.
Ɣ7ULPPRGH212))VHWWLQJ
When changing the trim mode, move the
cursor to the [TRIM] item and touch the RTN
button to switch to the data input mode.
Select ON/OFF by scrolling the touch sensor.
*The display blinks.
Touch the RTN button to change the trim
mode ON/OFF and return to the cursor
mode.
:KHQPL[LQJLQFOXGHVPDVWHUVLGHWULPVHOHFW>21@DQG
ZKHQPL[LQJGRHVQRWLQFOXGHPDVWHUWULPVHOHFW>2))@
ŏ 6HOHFW >6:$6+ 0,;@ DW WKH 0RGHO PHQX
and access the setup screen shown
below by touching the RTN button.
Scrolling
ŏ0RYLQJ FXUVRU
ŏ6HOHFWLQJ PRGH
ŏ$GMXVWLQJ YDOXH
ŏ7R QH[W SDJH
&XUUHQWO\VHOHFWHGFRQGLWLRQQDPH
ŏ&RQGLWLRQ VHOHFWLRQ