Futaba 8FG 2.4GHz - Manual (Page 53)

53 )XQFWLRQVRI/LQNDJH0HQX!
ŏ6HOHFW WKH IXQFWLRQ QDPH
and return to the Linkage
menu by touching the
RTN button.
<SensorTouch™>
02'(/7<3( This function selects the model type from among airplane, helicopter,
and glider.
7KHGLVSOD\VFUHHQLVDQH[DPSOH7KH
VFUHHQGHSHQGVRQWKHPRGHOW\SH
)RXUW\SHVRIPDLQZLQJVDQGWKUHHW\SHVRIWDLO
ZLQJVDUHDYDLODEOHIRUDLUSODQHV6L[VZDVKW\SHV
are available for helicopters. Six types of main
ZLQJVDQGWKUHHW\SHVRIWDLOZLQJVDUHDYDLODEOHIRU
gliders. Functions and mixing functions necessary
for each model type are set in advance at the
factory.
Note: The Model Type function automatically
selects the appropriate output channels,
control functions, and mixing functions for the
chosen model type.
When the Model Type selection command
is accessed, all of the data in the active
memory is cleared (except the following
swash type.) Be sure that you don’t mind
losing this data, or back it up to another
memory using the copying functions.
When changing the helicopter swash type
within the following groups, you can leave
the settings other than the SWASH function.
However, this is initialized when you change
the swash type to the other swash type
group.
0RGHOW\SHVHOHFWLRQ
1. Move the cursor to the item you want to
change and touch the RTN button to switch
to the data input mode.
Select the desired type by scrolling the
touch sensor and touch the RTN button. A
confirmation message appears. Touch the
RTN button for one second.
Move to [YES] and Touch the RTN button for
one second.
(To terminate input and return to the original
state, touch the S1 button or select [NO] and
touch the RTN button.)
"TYPE": Model type
"WING " (airplane/glider): Wing type
"TAIL" (airplane/glider): Tail type
"SWASH" (helicopter): Swash type
7KHZLQJW\SHVZKLFKFDQEHVHOHFWHGGHSHQGRQWKH)$667
PRGH0XOWLFKRUFKVHOHFWHG
ŏ 6HOHFW >02'(/ 7<3(@ LQ WKH /LQNDJH PHQX DQG
access the setup screen shown below by touching
the RTN button.
2. If resetting the data when changing the
helicopter swash type:
+HOLFRSWHU
Move the cursor to [OFF] and touch the RTN
button to switch to the data input mode.
Select [ON] by scrolling the touch sensor
and touch the RTN button. A confirmation
message appears. Touch the RTN button.
Activate the swash type setting. The swash
setting parameters are reset.
Swash type group A:
H-1, H-3, HR3, and HE3
Swash type group B:
H-4, H-4X
Scrolling
ŏ0RYLQJ FXUVRU
ŏ6HOHFWLQJ PRGH