Futaba 8FG 2.4GHz - Manual (Page 52)

52 )XQFWLRQVRI/LQNDJH0HQX!
[TX]: Transmitter memory
[CARD]: SD card
2. Move the cursor to the model you want to
delete in the model list and then touch the
RTN button.
3. Move the cursor to [DELETE].
 7RXFK WKH 571 EXWWRQ :KHQ D FRQÀUPDWLRQ
message is displayed and the RTN button
is touched for one second, the model is
deleted.
0RGHOQDPHFKDQJH
*The model name of the model stored in the transmitter
memory or a SD card can be changed.
1. If changing the location:
Move the cursor to the save destination
display ("TX" or "CARD") and touch the RTN
button to switch to the data input mode.
Select the save destination by scrolling the
touch sensor and touch the RTN button.
[TX]: Transmitter memory
[CARD]: SD card
2. Move the cursor to the model you want to
change in the model list and then touch the
RTN button.
3. Move to [RENAME].
4. Touch the RTN button.
*The model name setup screen is displayed.
8VHUQDPH FDQGLGDWH
4. Change the model name as described
below:
[Moving cursor in the user name (candidate)]
6HOHFW >ł@ RU >ń@ DQG WRXFK WKH 571 EXWWRQ
[Deleting a character]
When [DELETE] is selected and the RTN button
is touched, the character immediately after
the cursor is deleted.
[Adding a character]
When a character is selected from the
character list and the RTN button is touched,
that character is added at the position
immediately after the cursor.
$QDPHRIXSWRFKDUDFWHUVORQJFDQEHHQWHUHGDVWKH
PRGHOQDPH $VSDFHLVDOVRFRXQWHGDVRQHFKDUDFWHU
5. After the desired information has been input,
select [ENTER] and touch the RTN button.
(To terminate input and return to the original
state, select [CANCEL] and touch the RTN
button.)
0RGHOFRS\
*A copy can be made of the model stored in the transmitter
memory or an SD card.
1. If changing the location:
Move the cursor to the save destination
display ("TX" or "CARD") and touch the RTN
button to switch to the data input mode.
Select the save destination by scrolling the
touch sensor and touch the RTN button.
[TX]: Transmitter memory
[CARD]: SD card
2. Select the model you want to copy in the
model list and then touch the RTN button.
2. Move to [COPY].
3. Touch the RTN button.
*The copy screen appears.
4. I f r e p l a c i n g t h e m o d e l s t o r e d i n t h e
transmitter memory:
Move to [ADD-LIST] and touch the RTN button
to switch to the data input mode.
Select the destination model by scrolling the
touch sensor and touch the RTN button.
[ADD-LIST]: adding the model to the list
[(model name)]: replacing the model
*The model stored in the SD card can be replaced.
If changing the location:
Move the cursor to the copy destination
display ("TX" or "CARD") and touch the RTN
button to switch to the data input mode.
Select the save destination by scrolling the
touch sensor and touch the RTN button.
5. Move to [COPY].
 7RXFK WKH 571 EXWWRQ :KHQ D FRQÀUPDWLRQ
message is displayed and the RTN button is
touched for one second, the model data is
copied.