N :duqlqj, Rphvfuhhq – Futaba 8FG 2.4GHz User Manual
Page 24
24
%DVLF2SHUDWLRQ!
8S'RZQWLPHU6767
• Timer is displayed here.
Touch the RTN button at the [xx]:[xx.x]
item to start/stop the timer.
• Use the cursor to highlight this, then
touch the RTN button at the ST1 or ST2
item to call the timer set-up screen.
*See the description at the back of this manual.
n :DUQLQJ
j Be sure to confirm the model name before flying
your aircraft.
j Check the battery voltage as often as possible and
try to charge the battery earlier. If the battery alarm
PDNHVDVRXQGODQG\RXUDLUFUDIWLPPHGLDWHO\
<RX FDQ DGMXVW WKH /&' FRQWUDVW E\ WKH GLVSOD\ VHWWLQJ LQ WKH
System menu.
+RPHVFUHHQ
'LJLWDOWULP7WR7
• Trim position is displayed here.
• You can select the display unit
on the home screen on the
T1-T4 setting screen within the
linkage menu.
Model Name
• The model name
that is currently
used is displayed
here.
• U s e t h e c u r s o r
to highlight this,
then touch the
RTN button to call
8VHU VQDPH
6\VWHPWLPHU
• This shows the accumulated time since
the latest reset. (Hour):(Minute)
• Use the cursor to highlight this, then
touch the RTN button for one second
to reset the system timer.
8VHWKHWRXFKVHQVRUWRVHOHFWWKHIROORZLQJGLVSOD\DUHDWRFDOOHDFKVHWWLQJVFUHHQDQGWRXFKWKH571
button. The setting screen appears.
5)LQGLFDWRU
%DWWHU\,QGLFDWRU
• When the battery voltage
reaches 6.8V, the alarm will
beep. Land your aircraft
immediately.
FASST mode
• FASST mode is displayed here.
• Use the cursor to highlight this,
then touch the RTN button
to call the frequency set-up
screen.
2
nd
+RPHVFUHHQ
• Touch the RTN button at
the clock icon to call the
2
nd
home screen (large
size timer).
d
0RGHOWLPHU
• This shows the accumulated time
since the latest reset. (each model)
(Hour):(Minute)
• Use the cursor to highlight this,
then touch the RTN button for one
second to reset the model timer.
.H\ORFN
• Touch the S1 button for one second
to lock/unlock the key operation.
In the key lock mode the key icon is
displayed here.
0RGHOW\SH
6'FDUGLQGLFDWRU
&RQGLWLRQQDPH+HOL*OLGHU
• In the normal condition, move the
cursor to the condition name and
touch the RTN button. The condition
name is changed and blinked.
I t i s p o s s i b l e t o o p e r a t e t h e
digital trim other than the normal
condition.