Cisco XR 12406 User Manual
Page 124
Chapter 3 Installing the Cisco XR 12406 Router
Manually Booting the System
3-36
Cisco XR 12406 Router Installation Guide
OL-13831-01
The following is an example of a typical boot process:
•
The RP MBus module receives the correct DC voltage and starts executing
MBus software.
•
The RP determines the router configuration by sending a message through the
alarm card requesting all installed devices to identify themselves. Their
responses provide slot numbers and card and component types. The RP, line
cards, CSCs, and SFCs are then powered up.
•
The power-on-reset logic of the RP is delayed long enough to allow power
and both local and CSC clocks to stabilize.
•
After the power-on reset logic is released, the RP begins to execute the ROM
monitor software.
•
If the ROM monitor is configured to autoboot, it automatically loads and
boots the Cisco IOS XR software.
•
If the ROM monitor is not configured to autoboot, boot the Cisco IOS XR
software manually. See the
“Manually Booting the System” section on
.
•
When the Cisco IOS XR software boots, it polls all other cards in the system,
powers them up, and loads the Cisco IOS XR software they require.
Starting the Router and Observing Initial Conditions
Observe the following conditions the first time you start your router:
•
Power cables to the PDU are fully connected to both the PDU and the power
source, and are secured with appropriate strain relief.
•
Empty card slots or card bays are filled with card blanks. This ensures proper
air flow through the chassis and electromagnetic compatibility (EMC).
•
All cards are fully inserted in their cages and bays.
•
All captive screws are tightened.
•
Line card cable-management brackets are attached to their respective line
cards.
•
Interface cables are completely seated in their line card connectors.
•
Interface cables are routed neatly through the chassis cable-management
bracket.