Cisco XR 12406 - Manual (Page 188)

Chapter 5 Maintaining the Router
Removing and Replacing an AC PDU
5-24
Cisco XR 12406 Router Installation Guide
OL-13831-01
Step 9 Install the blower module ( Figure 5-13 ):
a. Position the alignment holes on the blower module with the guide pins on the
chassis and PDU.
b. Slide the blower over the guide pins toward the chassis until it mates with the
PDU connector.
Caution To prevent damage to the connectors, do not use excessive force when installing
the blower module.
c. Tighten the (4) captive screws to secure the blower module to the chassis.
d. Lower the carrying handle to its operating position.
Figure 5-13 Installing the Blower Module
Step 10 Reconnect the power cords to the PDU and secure them using their retention clips.
Step 11 Plug the power cords into their AC outlets.
Step 12 Power on the circuit breakers assigned to the AC outlets.
101115
HIGH SPEED BLO WER