Conair GB - Manual (Page 13)

SELECTING CORRECT MODEL
Controllers are programmed to control all sizes of Autoweigh Blenders.
The MODEL number that your unit is set for will be displayed during the
start up sequence every time power is turned on.
The possible models are:
MODEL BATCH WT valves WEIGH BIN LOAD CELL
(GRAMS) DIMENSIONS RATING
GBM 400 4 5 x 5 x 5 high 1 @ 3 K
140/14R 1000 4 10 x 6 x 6 high 1 @ 3 K
220 2000 2 10 x 10 x 7 high 2 @ 3 K
240/24R 2000 4 10 x 10 x 7 high 2 @ 3 K
420 4000 2 10 x 10 x 10 high 2 @ 10 K
440/44R 4000 4 10 x 10 x 10 high 2 @ 10 K
940 9000 4 16 x 16 x 12 high 2 @ 10 K
184 18000 4 16 x 16 x 17 high 2 @ 20 K
("R" models have 2 removable hoppers)
The addition of feeders will change the last digit of the model number.
This digit can be ignored for selecting the correct Model.
400, 1000 and 2000 gram systems with 3 kg. load cells; weights are
displayed in tenths of grams ( xxxx.x).
4000, 9000, and 18000 gram systems with 10 or 20 kg. load cells;
weights are displayed in full grams ( xxxxx).
If your unit is NOT set correctly to match the hardware you have, you
must change it. To do so:
Turn power on. From the NORMAL mode:
+-------------------------------------------------------+
¦ Press: * Display will say: (PASSWORD) ¦
¦ ¦
¦ Press: 97531 Display will say: (MODEL220) ¦
¦ or whatever model it is ¦
¦ currently set for. ¦
¦ ¦
¦ Press: * To walk through all model sizes. ¦
¦ When the model you want is displayed,¦
¦ then: ¦
¦ ¦
¦ Press: EXIT Wait a few seconds. ¦
¦ Unit will reset and restart ¦
¦ as the system you have selected. ¦
+-------------------------------------------------------+
When switching models, all parameter table information is lost and the
new "default" information for this model is loaded from ROM.
Page 14