Conair GB - Manual (Page 30)

recipe. Display = (GET --).
If no RECIPE is currently in use, display says (GET --).
Enter 2 digits to retrieve one of 50 recipes.
Display will flash through this recipe data:
(RCP 01), (1R= xx ), (2N= xx.x), etc., (* = LOAD)
Press "*" to LOAD this recipe into memory. Routine will
exit automatically. Press RCP or EXIT to return to the
display (GET --). Press RCP or EXIT again to exit.
To SAVE a RECIPE you must be in the PROGRAM mode.
If you press RCP key again after display of (GET --),
display says (SAVE --). Enter 2 digits, display will say
(SAVING ). The current settings are saved into memory under
the recipe number you have entered.
Routine will EXIT automatically.
EXIT will exit at any time.
To clear a recipe, set all component settings to zero and
save these settings into the recipe location.
BATCH: This key allows you to blend a PRE-SELECTED WEIGHT of
(BTCH) material, and then STOP running and sound the ALARM. The
process may also be programmed to sound the alarm but
continue running. Since each cycle will always blend a full
weigh bin amount, the total amount blended may exceed the
target batch weight by up to one cycle's blend weight.
This key is NOT FUNCTIONAL unless the last digit in the
"FLG" parameter is set to 1 or 2. (xxxx1 or xxxx2). To do
this, see the MAINTENANCE section, PARAMETER TABLE, "FLG".
The ALARM SILENCE button on the side of the controller, is
the ONLY way to CONTINUE OPERATION after a BATCH amount has
been run.
Assuming a proper "FLG" parameter is set:
Press the BTCH key once to view the desired BATCH WEIGHT.
Display will say (BW #####).
BATCH WEIGHT is the amount you wish to dispense before
stopping and/or sounding the alarm.
Press again to view the CURRENT PORTION, of the batch, that
has been dispensed.
Display will say (CP #####).
CURRENT PORTION shows how much of the Batch Weight you have
blended so far.
Press again to view the ACCUMULATED TOTAL weight of all
batches dispensed.
Display will say (AT #####).
ACCUMULATED TOTAL is the sum weight of all batches that have
been blended. This number will continue to grow until it is
manually cleared to zero, or it exceeds its maximum possible
value.
Page 31