Conair GB - Manual (Page 74)

print for additional components as necessary, printing only those
components turned on. Thumbwheel setting and material type is shown
for each. If a thumbwheel setting is changed, a new header line will
print.
In this example, component 1 is a REGRIND; component 2, a NATURAL; 3
and 4 are set up as ADDITIVES.
The CYCLE heading:
------------ ------------ ------------ ------------ ------
* 11/10/97 * * 16:17:53 * RECIPE 0000 **ID# 051** **WO 000000* OPR000
DATE and TIME this blend cycle was completed. RECIPE, ID, Work Order,
and Operator numbers have no bearing on blender operation but aid in
identifying this particular blender, and what job was running.
DATA line 1:
------------ ------------ ------------ ------------ ------
FINAL: DISP,% 0.0 .0 1908.3 77.6 4.06 0.0 .00 2000.1
For each material, each column shows the final dispensed weight of that
material and its percentage of the blend.
In this example Natural dispensed 1908.3 grams. Color dispense is 77.6
grams, 4.06 percent of the natural dispense, slightly over the 4
percent requested.
The final number, 2000.1 is the total weight of the blend. It equals
the sum of the component dispenses.
DATA line 2:
------------ ------------ ------------ ------------ ------
RATE: GR/TIME 18224 976 19993 488 12973 31232 10240 31232 9.9
These numbers show the RATE of dispense for each material. These are
the numbers that the software used to calculate how long to open the
slide gate or run an auger, in order to dispense the required amount.
This is GRAMS per Interrupts; 1822.4 grams dispensed in 976 interrupts,
which is 4 seconds.
The final number, 9.9 grams, is the TEAR WEIGHT of the weigh bin
displayed just before the cycle began.
DATA line 3:
------------ ------------ ------------ ------------ ------
1ST DISP,TIME 0.0 00 1908.3 469 77.6 1826 0.0 00 22
This shows the first dispense in grams for each material and the timing
of that dispense (in interrupts).
Page 75