Conair GB - Manual (Page 21)

INSTRUCTIONS FOR NORMAL OPERATION
OPERATION: ....very simple.
1. Fill HOPPERS.
2. Turn POWER ON. Verify correct settings.
3. On Controller, set STOP and PAUSE switches UP.
Turn MIXER motor switch DOWN to run for a timed period.
Unit will now operate automatically to maintain a level of material
high enough to cover the sensor.
Use the STOP or PAUSE switches to stop the blender.
Turn POWER off only on final shutdown.
----------------------------------------------------------------------
AFTER SEVERAL DAYS OF PROPER OPERATION:
Save all parameter information to the EEPROM for future retrieval just
in case software problems develop later.
To SAVE all parameter information to the EEPROM:
+---------------------------------------------------+
¦ Press: * Display will say: (PASSWORD) ¦
¦ Press: 22222 Display will say: (P x) ¦
¦ Press: * Display will say: (INSTR --) ¦
¦ Press: 23 Display will say: (SAVING ) ¦
¦ Wait: when done, Display will say: (P x) ¦
¦ Press: EXIT Display will say: ( x) ¦
+---------------------------------------------------+
If software related problems develop later, RETRIEVE this correct copy
of the parameters from the EEPROM. This clears corrupted data from RAM
and corrects most software problems.
To Retrieve:
+----------------------------------------+
¦ Switch: POWER OFF. ¦
¦ Hold: the "CE" key down. ¦
¦ Switch: POWER ON. ¦
¦ Release: the "CE" key. ¦
¦ Display will say ( CLEAR ) ¦
¦ If you do not see ( CLEAR ) ¦
¦ on the display, do it again. ¦
+----------------------------------------+
Page 22