Conair GB - Manual (Page 37)

The PARAMETER LIST looks like this:
+-----------------------------------------------------+
¦General ¦ Component: 1 through 9, and A, B, and C: ¦
+--------+--------------------------------------------¦
¦FLG 1TY 2TY 3TY CTY ¦
¦MIX 1CS 2CS 3CS and so on up to: CCS ¦
¦FCV 1AL 2AL 3AL CAL ¦
¦DTI 1XT 2XT 3XT CXT ¦
¦KDF 1SE 2SE 3SE CSE ¦
¦WDF 1WT 2WT 3WT CWT ¦
¦BER 1TI 2TI 3TI CTI ¦
¦ROC 1MI 2MI 3MI CMI ¦
¦ROV 1NC 2NC 3NC CNC ¦
¦RHL 1RP 2RP 3RP CRP ¦
¦FUL 1RD 2RD 3RD CRD ¦
¦MAX 1LA 2LA 3LA CLA ¦
¦ TH 1PT 2PT 3PT CPT ¦
¦ TI ¦
¦PRT ¦
¦DLY ¦
¦PRC ¦
¦...and so on down to: ¦
¦TRC ¦
+-----------------------------------------------------+
Press: PARA to ENTER the list at the TOP LEFT (FLG).
Press: PARA to move DOWN a list.
Press: * to move UP
Press: SET to move RIGHT (1st time, goes to 1TY)
Press: VIEW to move LEFT
Press: EXIT when finished.
In the COMPONENT lists:
The TOP parameter (TYPE) is ALWAYS accessible.
The others are NOT accessible unless TYPE is set.
The First press of the PARA key will enter the GENERAL list
at the top.
Then the first press of the SET key will move to top of the
first component list. Press the PARA key to move down in
any list.
While in one COMPONENT list, press the SET key to jump to
the same relative position in the next list. This allows
rapid scanning of like parameters in all component groups.
To change a displayed parameter enter a new number in place
of the old one. CE will cancel a number entry before the
last digit is entered. The purpose of each parameter is
explained elsewhere in this manual.
In any component list, if TYPE is set to "OFF"; (_TY= OFF);
other parameters in that list are not accessible.
EXIT will exit the sequence at any time.
Page 38