Conair GB - Manual (Page 45)

Use the "CE" key to toggle a component ON or OFF.
When ON, Display will say (C=ON 85).
You may change the 85 by entering a different number.
Too low will just add time. Too high will cause occasional
overshooting.
Press EXIT when done to save new settings.
*86 Press (*,8,6) to select a new "Back Door" password for your
software. Display will say (BDP 00000). Enter 00001 up to
00009 to select one of nine new backdoor passwords. Contact
us for the actual number. If you just want to kill the use
of a backdoor password altogether, just enter a number from
1 to 9, and don't call us. Then no one in you plant will
know the number. But we still will, just in case. Then
your own selected regular password will work and as long as
you don't forget it, your ok.
Blenders are pre-programmed with two normal passwords;
(22222) is the default password for the PROGRAM mode,
(11111) is the default password for the MANUAL mode. You
can alter these passwords to any 5 digit number, but you
must know the current PROGRAM password to change it. If for
some reason the password has been altered and you can not
remember it, we have a special "backdoor" password that will
let you in no matter what. For obvious reasons, we do not
provide that password in this manual. You must call us.
However, there is a problem. If the wrong person in your
factory obtains this password, then he will always have
access to the Program mode of the blender no matter what.
Now, with this star function, you have the option to select
from 10 different "backdoor" passwords. If your current
"backdoor" password is known to the wrong person, you can
call us for a new one. We will not give these backup
passwords to just anyone. In fact, since only I know them,
it is not that easy to obtain these numbers.
To activate a new "backdoor" password, you will enter a
number from 00000 to 00009 using this star function. each
number activates a different password. entering 0 activates
the current backdoor password, the one we have used for over
10 years. For a new one, call us and talk with someone you
know here in the office and they will supply a number from 1
to 9, and the associated new "backdoor" password.
After this new "backdoor" password is selected, you can
safely change the regular password to one only you know, and
use that in normal production. No one will be able to use
the backdoor to get in. If you forget your regular
password, and you also forget which backdoor password you
selected, then we will help you go through the entire list
to find the one that works.
*87 Press (*,8,7) to set flag for operation in a VOLUMETRIC
mode. Use the * key to toggle flag ON or OFF. Press EXIT
when done. When power is turned off this flag is always
reset to OFF. With this flag ON (VOLUMETRIC mode), the load
cells are completely ignored. Error correction and rate
Page 46