CTC Store CTS Union IP DSLAM for ADSL IPDSLAM-A8/A16 - Manual (Page 117)

ADSL IP DSLAM
109
executing TFTP to ADSL IP DSLAM.
Example
IPDSLAM# upgrade enable
Yes or No <y/n>? y
System is in the “upgrade” mode now. You could start to upgrade the
system file.
Note: This step can be skipped, in case of without Ethernet-VLAN on each
port.
Step 3: Enter the command “ show sysip” to get the <IP address> of ADSL IP
DSLAM. If you already know the IP address, you can skip this step.
Example
IPDSLAM# show sysip
IP: 192.168.10.2
Submask: 255.255.255.0
Gateway: 192.168.10.1
Note: Make sure that the system IP and your computer is in the same subnet.
Step 4: Open another window interface, e.g., MS-DOS interface.
Step 5: Enter the command “tftputil <IP address> <get> <sf_user.cfg>” under
the directory of configuration file and control files.
Example:
c:\> tftputil 192.168.10.2 get sf_user.cfg
When uploading, three LEDs, “MAINT” “ALARM” and “FAULT”, will
blink. Unless you finish uploaded, do not shut down ADSL IP DSLAM.
Step 6: Restart the system in terminal emulation interface. The system will
restart according to your “sf_user.cfg”.
Example
IPDSLAM# restart
Yes or No <y/n>?
System is restarting now.Wait…..
5.1 Configuration Restore
Describes how to restore your configuration settings from computer to ADSL IP
DSLAM. The following procedures will help you to restore configuration:
Step 1: Open the hyber terminal interface in order to execute CLI.
Step 2: Enter the command “ show sysip” to get the <IP address> of ADSL IP