CTC Store CTS Union IP DSLAM for ADSL IPDSLAM-A8/A16 - Manual (Page 119)

ADSL IP DSLAM
111
5.2 ADSL IP DSLAM upgrade procedure
This section describes how to upgrade the software of your ADSL IP DSLAM.
Step 1: connect your PC with the UPLINK port of ADSL IP DSLAM by using an
Ethernet cable.
Step 2: Prepare an new ADSL IP DSLAM software (filename, IP16s_TFTP_
V243_DLINK.BIN, is taken as an example here) and the TFTP utility.
Step 3: Extract the TFTP utility, “tftp.zip”, into one directory of your PC.
Step 4: Rename the filename “IP16s_TFTP_ V243_NoBrand.BIN” as “ipam”
and put into the same directory with TFTP.
Step 5: Log in CLI by using a RS-232 cable and type the command” sysip” to
access the IP address of ADSL IP DSLAM. (This step can be skipped
if the IP address of ADSL IP DSLAM has been available).
Step 6: Activate the “MS-DOS mode” and enter the directory that you made for
TFTP utility.
Step 7: Key in the following command to upgrade your ADSL IP DSLAM:
C:\TFTP\tftputil 192.168.100.111 put adsl
C:\TFTP \tftputil 192.168.100.111 put ipam
Transfer successful: 8 bytes in 1 second, 8 byte/s
Transfer successful: 2097152 bytes in 91 seconds, 23045 byte/s
C:\TFTP\tftputil
C:\TFTP\tftputil
Step 8: After entering this command, ADSL IP DSLAM will be processing
upgrade immediately. When ADSL IP DSLAM is upgrading, LED,
“MAINT” “ALARM” and “FAULT”, will be blinked. It takes 20 seconds to
complete upgrade if there is no power off during the procedure.
Step 9: Once those 3 LEDs stop blinking, the software upgrade is completed
and ADSL IP DSLAM will restart automatically.
Step 10: Enter ADSL IP DSLAM CLI again and type the command, “show
sysinfo” to verify the software version. The version shall be “2.43”