PRG DMX Reference Guide 5.4 - Manual (Page 52)

44 DMX512 REFERENCE GUIDE
CABLES
Note: Refer to "Cable/Connector Terminology" on page 3 for appropriate metric equivalents.
Pig Tails
The pig tails used for the 200A AC Line Disconnect are a set of 10-foot, 2/0 power cables with Cam-Lok receptacle
connectors on one end and bare wires on the other end. The bare wires are used to connect to the house service.
The pig tails used for the 30A mini-ACS line disconnect are a set of 10-foot, 8/5 power cables with bare wires on one
end and a Hubbell receptacle connector on the other.
Power Input Cables
The power input cables are 2/0 cables rated at 200A, using color-coded Cam-Lok connectors to denote three
phases, neutral, and ground. The cables are available in 20- and 80-foot lengths with Cam-Lok connectors on both
ends.
The power input cable for the mini-ACS rack has a Hubbell plug on one end and a Hubbell receptacle on the other.
Mini-AC Disconnect to SixPack Chassis Input Cable
This input cable is used to supply power to a SixPack Chassis or a
NIF unit when used with a mini-AC disconnect unit. This cable is
connected to the mini-AC disconnect using the Hubbell connector.
To use with a NIF, the Epic connector is mated to a "modular rack-to-
NIF-unit" power cable. (Note the NIF unit end of the modular rack to
NIF unit power cable utilizes a single clamping mechanism.)
Modular Rack to Mini-ACS Rack Input Cable
This input cable is used to supply power to a mini-ACS rack when
used with the modular rack. This cable uses a Hubbell receptacle on
one end and an Epic plug on the other. It is connected from the AUX
1 or AUX 2 Epic receptacle at the modular rack to the Hubbell plug at
the mini-ACS rack.
For AC Line
Disconnect
For Mini AC
Line Disconnect