PRG DMX Reference Guide 5.4 - Manual (Page 72)

64 DMX512 REFERENCE GUIDE
Series 300 Hanging Hardware: VL7
The VL7 luminaire requires a different type of truss attachment hardware than the other Series 300 luminaires. For the
VL7 luminaire, two types of clamps are available: a round pipe clamp for 2" pipe applications and an adjustable clamp
for square pipe or other applications. A single truss clamp, attached to the pan tube, is used for a standard horizontal
hang. A vertical hang can be achieved using an appropriate vertical hang assembly in combination with a truss clamp.
Figure 3-15: VL7 Clamps
When installing a VL7 luminaire with the round pipe clamp, swing latch up and back as far as possible. If the latch is
not in the proper position, the clamp will not fit on the pipe.
Figure 3-16: VL7 Round Pipe Clamp Orientation
VL7 Vertical Hang Assemblies
A special vertical hang can be achieved by using a vertical hang assembly. This assembly consists of several
components that attach to the truss clamp. Depending on the truss clamp, round pipe or adjustable (square pipe), a
different vertical hang assembly will be required.
VL7 Round
Pipe Clamp VL7 Square
Pipe Clamp
HKINSTAL
Latch Wing Knob
Correct Incorrect
Clamp Bolt
Clamp will bind
on pipe. Truss Pipe