PRG DMX Reference Guide 5.4 - Manual (Page 53)

DMX512 REFERENCE GUIDE 45
Series 200 Trunk Cable
Series 200 trunk cables distribute power and data to
Repeater Boxes for Series 200 luminaires. This cable uses a
41-position Pyle-National or Matrix Science connector. The
cables are color-coded at each end to denote length: blue
(100 feet), green (60 feet), white (30 feet).
Maximum recommended length is 500 feet.
APS Trunk Cable
APS trunk cables (also called APS6 cables or APS6 trunk runs)
distribute lamp power from SixPack chassis or conventional
lighting dimmers to Smart Repeater units for Series 300 luminaires.
This cable uses a 19-position Veam-Socapex compatible
connector. The cables are color-coded at each end to denote
length: blue (100 feet), green (60 feet), white (30 feet). This cable is
similar to a standard Socapex cable except it contains special
shielding for operation of VL5Arc/VL6/VL7 luminaires. When only
operating VL5/VL5B luminaires on a Smart Repeater unit, industry standard 19-pin Socapex cables can be
substituted for APS trunk cables.
Maximum recommended length is 1000 feet.
Series 200 Lamp Cable
Series 200 lamp cables are shielded cables with a 9-pin Amp CPC connector at both ends. They are
used as follows:
+ To connect Series 200 luminaires to Repeater Boxes.
+ To connect interface units and Smart Repeater units to Repeater Boxes and mini-ACS racks.
+ To connect master ACS racks to slave ACS racks.
The cables are color coded at each end to denote standard lengths. For Series 200 lamp cables: white
(6 feet), red (12 feet), yellow (20 feet), orange (50 feet), blue (100 feet).
Maximum recommended length is 100 feet.