VACUUBRAND PC 620 NT plastic housing - Manual (Page 105)

page 105 of 113
PC 300x VARIO
fuse holder
➨
Keep the snap-fit squeezed and pull the fuse holder out.
➨
The fuse holder contains two fuses of the same type. Replace the
defective fuse by a fuse of the same type (see “Technical data”, pg.
26)
➨
Insert the fuse holder into the housing of the pumping unit until it snaps.
Replacing the device fuse
➨
Switch off the pump.
➨
Disconnect the electrical power cord before un-
screwing the fuse holder.
Identify and eliminate the cause of failure before switch-
ing on the pump again.