Move the bin to approximate location, Uncrate the machine section, Remove the front top, and side panels – Carrier 26H User Manual
Page 11: Installation, Carrier
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Carrier
INSTALLATION
26H
m
7. MOVE THE BIN TO APPROXIMATE
LOCATION
Move the bin as close as possible to the final lo
cation before placing the machine section on top
of it.
8. UNCRATE THE MACHINE SECTION
Uncrate the machine section as shown in Figs. 3
and 4.
FIG. 3 - UNCRATING - REAR BOLTS
BOTTOM BOLT
9. REMOVE THE FRONT TOP, AND SIDE
PANELS
Remove the front, top, and side panels in that order
before moving the machine section.
FIG. 5 - REMOVING SCREWS HOLDING TOP
AND SIDE PANELS
10. PLACE MACHINE SECTION ON TOP OF BIN
AND BOLT IN POSITION
Remove the short front panel. Using the two cap
screws in the cloth bag shipped with the bin, bolt
the machine section in place as shown in Fig. 6.
FIG. 4 ■ UNCRATING - BOTTOM BOLTS
FIG. 6 - BOLTING MACHINE SECTION TO BIN
II
26H-57PD