Variation of cubes, Crusher, Fig. 22 - crusher guard assembly – Carrier 26H User Manual
Page 39
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
S E R V I C E
26H
18. VARIATION OF CUBES
Usually 18% of the cubes will vary from the standard
as follows:
1. Due to the slight taper of the freezing column
the cubes formed in the bottom will have a
larger external dimension than those formed at
the top.
2. The top and bottom cubes in each column will
have a slightly larger hole than those in the
center.
3. The first column to freeze nearly shut, thereby
causing water to overflow and end the freezing
cycle, will produce one or more cubes with
smaller holes.
19. CRUSHER
CRUSHER GUARD
The same crusher guard assembly may be used for
bins with and without partitions. It is necessary,
however, to adjust the position of this assembly
depending on whether or not the partition is used.
Refer to Fig. 22 which shows the crusher guard
and also explains how to install it.
CRUSHER LUBRICATION
The crusher and the crusher motor require periodic
lubrication. Fill the cups with SAE 20 oil (approxi
mately every 6 months). The crusher is equipped
with oilite bearings both front and rear, and since
the rear bearing carries the load, there is an oil
tube leading to it. When oiling the crusher motor,
put 10-15 drops of oil in the oil tube leading to the
crusher rear bearing.
REMOVAL OF CRUSHER
The crusher assembly is removable from the front
of the unit. First open the main disconnect switch.
Remove the control knobs, both front and side
panels, the inner access door, ice deflector, splash
curtain and the side baffles. Remove the galva
nized channel and the screws along the top edge
of the crusher. Remove the screws at the base of
the crusher. A removable stainless steel clip is
used to hold the water pan and ice crusher housing
together.
When replacing the crusher switch-knobs,make sure
they are positioned to agree with the printed decal
markings.
HOLE I (LOCATE HERE
FOR BINS WITHOUT
PARTITION)
LOCATE HOLE 2 HERE
FOR BINS WITH
PARTITION
HOLES 3 a 5-LOCATE WITH
HOLES ON UNDERSIDE OF
BIN TOP FOR BINS WITH
PARTITION-
HOLES 4 86 (ON END OF
TAB NOT SHOWING) LOCATE
WITH HOLES ON UNDERSIDE
OF BIN TOP FOR BINS
WITHOUT
partition
-
fig
. 22 - CRUSHER GUARD ASSEMBLY
39
26H-57PD