Carrier 26H - Manual (Page 9)

Carrier INSTALLATION 26H
-m
#
1. CHECK SHIPMENT
The unit is shipped in three cartons. One contains
the machine compartment, one the storage bin and
one the siphon interchanger assembly.
TABLE 1 - PARTS LIST
MACHINE SECTION CRATE
Model Quantity Description
26H3 1 Machine Section
1 Outside Standpipe
1 Water Strainer
1 Crusher Guard*
1 Inside Standpipe &
Rubber Grommet
26H5 1 Machine Section
1 Outside Standpipe
1 Water Strainer
1 Crusher Guard*
1 Inside Standpipe &
Rubber Grommet
On units equipped with crusher only.
STORAGE BIN CRATE
Size, Lb. Quantity Description
100, 160, 240, 1 Storage Bin
500 4 Leveling Screws
HEAT INTERCHANGER PACKAGE
Quantity Description
1 Interchanger
1 Rubber Hose
2 Hose Clamps
STORAGE BIN PARTITION
Quantity Description
1 Partition
Machine Screws
2. SELECT PROPER LOCATION
Select a location for the unit before delivery. The
following should be considered:
1. Convenience - Select a clean dry place as
close as possible to the point of ice consump­
tion. Consult the user before deciding.
2. Room Temperatures
Minimum 50 F - Room temperatures below this
may cause erratic control operation.
Maximum 100 F - Room temperatures above
this overload the compressor and reduce unit
capacity.
3. Floor Strength - See Table 2.
TABLE 2 - OPERATING WEIGHT AND
DIMENSIONS
Model No.
Total Weight
(Bin Full of Ice)
Bin
Cap. Floor
Area (In.)
26H3 389 100 25
X
24
26H5 565 160 25
X
24
26H5 676 240 25
X
34
26H5 940 500 32 x50
NOTE: Add 40 lb for Crusher.
4. Clearance:
Top
Rear and Sides
Front
10" Minimum
6" Minimum
24" Minimum
5. Water Supply - See Section 12.
6. Drain Connections - See Section 12.
7. Electrical Connections - See Section 13.
3. MOVE UNIT TO LOCATION
Move the unit to the proper location before uncra­
ting. Crated dimensions are shown in Table 3.
26H-57PD