4 checking the configuration, 3 checking the configuration -16, Checking the configuration – Nortel Networks 8000 User Manual

Page 325

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Nortel Secure Router 8000 Series

Configuration -WAN Access

8 Frame relay configuration

fr map ip { ip-address [ mask ]

| default } dlci-number compression frf9

The command creates an FR mapping and enables FR FRF.9 compression on DLCI.

You configure this command only on the FR main interface or point-to-multipoint FR
sub-interface, and the packet encapsulation type must be IETF. If the packet encapsulation

type is nonstandard, and when you run the command to enable the FR FRF.9 compression, the

system prompts that the nonstandard encapsulation type does not support FRF.9 compression.

CQ NOTE

The FRF.9 compression is suitable for the low-speed link.

The MFR link does not use the FRF.9 compression.

The FRF.9 compression has one synchronization procedure. During the compression, the packets are
in disorder. Usually, the compression does not succeed.

—End

A

If the two main interfaces that connect DTE and DCE satisfies the following two conditions:

You configure the FRF.9 compression on the two main interfaces.

The DLCI of the main interface at the DTE side is learned through the dynamic address
mapping.

After running the

undo fr map ip

{ ip-address |

default

} dlci-number command on the main

interface at the DTE side succeeds, you must restart the two main interfaces to make the DTE
and DCE communicate normally.

8.9.4 Checking the configuration

Run the following commands to check the previous configuration.

Action

Command

Check whether the frame relay

compression takes effects.

display fr pvc-info

Check the statistics of FR

compression.

display fr compress

[

interface

interface-type

interface-number ]

Run the

display fr pvc-info

command. The configuration succeeds when the statistics of

FRF.9 compression appears. In the following display, the FRF9 compression status is

"OPERATION", which indicates the FR FRF.9 compression is validated.

<Nortel> display fr pvc-info

PVC statistics for interface Serial6/0/0 (DCE, physical UP)

DLCI = 200, USAGE = LOCAL (0010), Serial6/0/0.1

create time = 2006/09/01 16:18:00, status = ACTIVE

in BECN = 0, in FECN = 0

in packets = 76, in bytes = 44727

out packets = 38, out bytes = 41736

Issue 5.3 (30 March 2009)

Nortel Networks Inc.

8-35

Advertising