Nortel Networks 8000 - Manual (Page 354)

8 Frame relay configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
Check the status of the master and the standby groups as GOOD on Router B.
<RouterB> display fr standby group 1
Group 1, AUTO mode, STANDBY state:
MASTER, Total 1 PVCs,1 PVCs is ok; DOWN PVCs critical value:100%
Bad PVCs list:
Good PVCs list:
OUT Serial2/0/0 VC:300 STATUS:GOOD; IN Serial1/0/0 VC:100 STATUS:GOOD
STANDBY, Total 1 PVCs, 1 PVCs is ok; UP PVCs critical value: 100%
Bad PVCs list:
Good PVCs list:
OUT Tunnel3/0/1 VC:200 STATUS:GOOD; IN Serial1/0/0 VC:100 STATUS:GOOD
Router A can ping through the interface of Router D.
<RouterA> ping 196.1.1.2
PING 196.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 196.1 .1.2: bytes=56 Sequence=1 ttl=254 time = 3 ms
Reply from 196.1 .1.2: bytes=56 Sequence=2 ttl=254 time = 3 ms
Reply from 196.1 .1.2: bytes=56 Sequence=3 ttl=254 time = 3 ms
Reply from 196.1 .1.2: bytes=56 Sequence=4 ttl=254 time = 3 ms
Reply from 196.1 .1.2: bytes=56 Sequence=5 ttl=254 time = 3 ms
-- 196.1.1.2 ping statistics ----
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 3/3/3 ms
—End
Configuration files
• Configuration file of Router A
#
sysname RouterA
#
interface Serial1/0/0
link-protocol fr
ip address 196.1.1.1 255.255.255.0
#
return
• Configuration file of Router B
#
sysname RouterB
#
fr switching
#
interface Ethernet3/0/0
ip address 10.1.1.1 255.255.255.0
#
interface Serial1/0/0
link-protocol fr
fr interface-type dce
8-64 Nortel Networks Inc. Issue 5.3 (30 March 2009)