3 maintaining interfaces, 1 clearing interface statistics, 2 debugging interfaces – Nortel Networks 8000 User Manual
Page 40: 3 maintaining interfaces -10, 1 clearing interface statistics -10, 2 debugging interfaces -10, Caution
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1 WAN access overview
Nortel Secure Router 8000 Series
Configuration -WAN Access
Output queue : (Protocol queue : Size/Length/Discards) 0/1000/0
Output queue : (FIFO queue : Size/Length/Discards) 0/256/0
Interface is V35
0 packets input, 0 bytes
0 packets output, 0 bytes
Run the
display ip interface brief command. The configuration succeeds when brief IP
information and physical status of an interface appear. For example:
<Nortel> display ip interface brief
*down: administratively down
(l): loopback
(s): spoofing
Interface
IP Address
Physical Protocol Description
Pos6/0/0
10.1.2.2
up
up NORTEL
1.3 Maintaining interfaces
This section covers the following topics:
•
1.3.1 Clearing interface statistics
To clear the statistics, run the following
reset command in the user view.
Action
Command
Clear the interface statistics.
reset counters interface [
interface-type
[
interface-number
] ]
1.3.2 Debugging interfaces
A
CAUTION
Debugging a^ects the performance of the system. After debugging, run the
undo debugging
all command to disable it immediately.
When a fault occurs on an interface, run the
debugging command in the user view to locate
the fault.
For the
debugging command related to specific interface, refer to corresponding maintaining
sections in this manual.
1-10
Nortel Networks Inc.
Issue 5.3 (30 March 2009)