Preconfiguration tasks, Data preparation, 2 configuring the clock mode – Nortel Networks 8000 User Manual
Page 448: 2 configuring the clock mode -5, Configuration, Procedures
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration -WAN Access
11 High-speed ATM configuration
When using an ATM interface, you need to configure its attributes.
Preconfiguration tasks
None.
Data preparation
To configure an ATM interface, you need the following data.
Configuration
No.
Data
1
Number of the ATM interface on the router
procedures
No.
Procedure
1
2
3
4
5
6
11.2.2 Configuring the clock mode
Do as follows on the routers:
Step 1
Run:
system-view
The system view appears.
Step 2
Run:
interface atm interface-number
The ATM interface view appears.
Step 3
Run:
clock { master | slave }
The command configures the clock mode of the ATM interface i.
By default, the clock mode is the slave mode for a high-speed ATM interface.
• Master mode indicates that the interface uses the internal clock signals.
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
11-5