A&D GR Series GR-300 - Manual (Page 44)

Calibration Report using an external weight
Key operation
Step 1 Press and hold the i CAL| key until displaying
r n I
L I I L 0 U c
Release the key.
n
u Step 2 The balance displays \ [ h ! i
□ If you want to change the calibration weight value, proceed to step 3.
□ If you use the stored calibration weight value in the balance, proceed to step 4.
Step 3 Press the [RANGE key and adjust calibration weight using the following keys.
RE-ZERO I key The key to set the value of the digit selected.
RANGE key The key to select the digit to change value.
№INT
I
key The key to store a new weight value and return to step 2.
CAlj key The key to cancel this change and return to step 2.
Step 4 Press the PRINT key. The zero point is measured and this value is
displayed.
Step 5 Place the calibration weight on the pan and press the PRINT key. The
weight is measured and this value is displayed.
Step 6 Remove the weight after [£noJ is displayed.
Step 7 If the calibration report is output
is output.
r / n
LI L I
is displayed and the GLP data
Step 8 The balance returns to the weighing mode automatically.
AD-8121 format
_ r I
I I I I LI I
Data format
i ii) i;i [.. (5 F?...... FF: i:i FFi
1-i 1 ;;F;;3 4F:F6 7TE;
^ iT3C:[:MEF-HiH
iFj !4 T FF: F; f FF; .■■■■ FF: .:]■ ’ FFi FF^
1 -F FF: :;F: ;; 3- FF f F" i n
FF:FT,TFFF:FEiTT EF:F(F:::TT. F^
FFiT .. ¡JF’ T RFiT
— Factory —
—
Product —
Serial number
— ID number -
----- Date --------
----- Time---------
- Calibration type
Calibration weight
— Signature
-- Space mark, ASCII 20H.
<TERM> Terminator mark, or S.
C r Carrige return mark, ASCII ODH
Lp Line feed mark, ASCII OAH
f n I" O L
A & D<TERM>
MODEL GR-200<T£flM>
S/N 12345678<TERM>
ID ABCDEFGH<r£RM>
DATE<rtfiM>
<TERM>
TIME <TERM>
<TERM>
CALIBRATEDCEXT.)<T£RM>
CAL.WEIGHT<rERM>
-^200.0000 g<TERM>
SIGNATURE<rE,RM>
<TERM>
<TERM>
-----------------------------^TERM>
<TERM>
<TERM>
Example of GR-200
Functions page 43 10, The ID Nunnber, GLP Report