A&D GR Series GR-300 - Manual (Page 45)

Calibration Test Report using an external weight
Key operation
Step 1 Press and hold the CAL |key until displaying rr o u t . Release the key
Step 2 The balance displays Г/
LI
□ If you want to change the target weight value, proceed to step 3.
□ If you use the stored target weight value in the balance, proceed to step 4,
Step 3 Press the RANGE key and adjust target weight using the following keys.
RE-ZERO I key The key to set the value of the digit selected.
RANGE j key The key to select the digit to change value.
PRli^ key The key to store a new weight value and return to step 2.
CAL I key The key to cancel this change and return to step 2.
Step 4 Press the ¡PRINT key. The zero point is measured and this value is
displayed.
Step 3 Place the calibration weight on the pan and press the PRINT key. The
weight is measured and this value is displayed.
Step 4 Remove the weight after J
I I LI
is displayed.
Step 5 If the calibration test report is output , ¡ [ i j P j is displayed and the GLP
data is output.
Step 6 The balance returns to the weighing mode automatically.
AD-8121 format Data format
- c - I
I I I I LI I
a Я; D
i5 fi;.2: :э
S-T2 1
i: [)
[) ;2 'T FI '2 FF: .■■■' FF: ^4 •■■■ Fi FF^
1 4- s F5 F; i s 2: ¿F i- ri
FFLHL . TE:FF:T<FF22T2.
ft : t fj f : l
F3
-r FF; ij F:i „ F;i FFi FFi FF; 'FF
'FF^
FF;
— Factory —
—
Product —
Serial number-
— ID number -
—
Date--------
-----Time —
— Cal. test type -
Zero point value
-Target mass value
Target weight
Signature
-- Space mark, ASCII 20H.
<TERM> Terminator mark, '- f or ^ r .
C r Carrige return mark, ASCII ODH
Lp Line feed mark, ASCII OAH
10, The ID Number, GLP Report Page 44
I n I о c
A & D<TERM>
MODEL GR-Z00<TERM>
S/N 1Z34567 8<TERM>
ID ABODE FGH<TER/M>
D AT E<TERM>
<TERM>
Т1МЕ<ГЕЯ/И>
<TERM>
CAL.TEST(EXT.)<TERM>
ACTUAL<TERM>
0.0000
+Z00.0002
TARGET <TERM>
+200.0000
SIGNATURE<rERM>
<TERM>
<TERM>
-------------------------------------<TER/W>
<TERM>
<TERM>
g <TERM>
g <TERM>
g <TERM>
Example of GR-200
Functions